EVDash is a Palm OS application that acts as a set of dash board gauges for electric vehicles. It displays battery pack voltage, amps being drawn from the battery pack, and two different estimates of remaining battery capacity. It works with Xantrex's Link 10, formerly called the E-Meter. Just plug the Palm device into the E-Meter, preferably through an optical isolator to protect the Palm device and start the EVDash program.
- Voltage - Battery pack voltage.
- Amps - Amps being drawn from or put back into the battery pack.
- Capacity based on voltage - Capacity calculated from the pack voltage under very low load. Voltage drops off as pack capacity drops.
- Capacity based on amps - Capacity calculated from the amps drawn integrated over time compared to the pack capacity. The peukert effect is taken into account.
Once you install the EVDash.prc on the Palm pull down the menu and go to the setup window. Enter the pack capacity and the Peukerts constant. The state of charge voltages should be determined experimentally by recording the voltages as the battery pack is completely discharged.
To transfer ASCII data from your Palm, use the standard Hot sync cable and a terminal program. Set the following communications information:
Supported operating systems:
Palm OS 3.x, Palm OS 4.x, Palm OS 5.x
Similar Software:
PButton If the device is switched off for at least the preset time then selected application is launched after next powering up using power button
TealMemBrain TealMemBrain - Memory Manager and Crash Stopper:
Manage your Memory
Stop crashes and monitor your memory use with TealMemBrain, the application stack stabilizer. TealMemBrain boosts your stack space on OS3 and OS4 handhelds, eliminating the major cause of system instability
StreakHack StreakHack - Does your Palm 'streak'? Some Palm IIIx and Vx machines show 'streaking', shadow lines extending from vertical and horizontal lines on the display. This is especially noticeable in the Calendar view in the DateBook app.
StreakHack can help reduce the streaking. After activating StreakHack in HackMaster, adjust the contrast to your liking
Sleep for Palm OS Sleep for Palm OS is designed to convert one of your hardware buttons into a fully functioning power button. This is useful for replacing a power button that has worn out.
Sleep can also be used to move the power button to the front of the pda for convenience. Sleep is fully supported on OS version 3.0 devices and up. It is also fully OS 5 compatible
EnterHack EnterHack - This hack is useful for persons who like taking graffiti shortcuts to navigate through palm programs.
With EnterHack you can enter a 'linefeed' stroke (the one from upper right to lower left) in the graffiti area to close the active form
PrefsPlus PrefsPlus is an easy to use utility that gives you more preferences
CableSync Hack CableSync Hack is a very small hackmaster hack that allows the user to hotsync by holding down either the up or down key while the power is turned on.
It is intended for users that have a cable, rather than a cradle.
CableSync Hack would also be appropriate for users that have remapped their hotsync button, or have a broken hotsync button
AppLight Hack AppLight Hack - control the Backlight state for a specific application
NoDebug NoDebug disables the shortcut to enter to debug mode, preventing that anyone could active it, even, when it's locked.
WARNING:
Only removes the shortcut, there are other ways to get in debug mode!
It includes the source code. (Works with x-master too)
TreoPref TreoPref - Save and Restore Treo Settings
Other Software by developer «Peter Ohler»:
EV1Dash EV1Dash is a program for Palm OS devices that will collect data from the EV1 and display it on the Palm OS device display. The intent is to provide more information to the driver so that range and performance can be optimized. Here is one of the displays. There are two other displays
