EVDash is a Palm OS application that acts as a set of dash board gauges for electric vehicles. It displays battery pack voltage, amps being drawn from the battery pack, and two different estimates of remaining battery capacity. It works with Xantrex's Link 10, formerly called the E-Meter. Just plug the Palm device into the E-Meter, preferably through an optical isolator to protect the Palm device and start the EVDash program.
- Voltage - Battery pack voltage.
- Amps - Amps being drawn from or put back into the battery pack.
- Capacity based on voltage - Capacity calculated from the pack voltage under very low load. Voltage drops off as pack capacity drops.
- Capacity based on amps - Capacity calculated from the amps drawn integrated over time compared to the pack capacity. The peukert effect is taken into account.
Once you install the EVDash.prc on the Palm pull down the menu and go to the setup window. Enter the pack capacity and the Peukerts constant. The state of charge voltages should be determined experimentally by recording the voltages as the battery pack is completely discharged.
To transfer ASCII data from your Palm, use the standard Hot sync cable and a terminal program. Set the following communications information:
Supported operating systems:
Palm OS 3.x, Palm OS 4.x, Palm OS 5.x
Similar Software:
TrapWeaver TrapWeaver is a utility for the Palm OS which protects your device from crashing due to overlapping system patches. If you install HackMaster hacks or run 3rd-party apps that patch the OS, you need TrapWeaver! TrapWeaver stabilizes your device by transparently managing and protecting ALL system patches from writing over one another
Fast Cap Hack Fast Cap Hack - help inputing capital letters without writing the cap. shift.
You can input the capital letter by writing across the alphabet area and numberic area.
I develop this hack for own use. But I would like to share it as freeware if anyonelike it. So, USE AT YOUR OWN RISK.
· Resolve the conflict with Chinese OSs (The main reason I write this hack
AlwaysOn (Palm OS) AlwaysOn (Palm OS) is a simple little application that lets you change the auto-off time of your Palm to some different values than possible with the built-in preferences. Especially it is possible to disable the timer completely.
What's New in This Release:
· Added color icons, confirmed compatibility with OS 3
PocketHAL PocketHAL - The American Conference of Governmental Industrial Hygienists (ACGIH) recently established a new Threshold Limit Value(R) for the hand, wrist, and forearm, known as the "Hand Activity Level," or "HAL"
AutoDigi for Palm OS Does your palm's digitizer get misaligned frequently? Do you need to re-calibrate your digitizer repeatedly? Does your digitizer fail after a reset? AutoDigi is the complete solution to your digitizer woe
ShutOff! ShutOff! shuts off your device after a period of some seconds.
· Countdown between 2 and 30 seconds
· Can simulate autopoweroff (Softoff) or hardbutton-use (Hardoff)
· Beeptones every second or once before shutoff or quiet
· Pause-button
· High security when used with PadlockHacks smartoption
Two Key On Hack Two Key On Hack makes it so your Palm will only turn on when the contrast button is pressed, so you have to press the contrast button plus another button.
This is a very simple way to overcome the problem of your Palm V turning on in your pocket
BigButton BigButton - If you have your hands full and you can't use the stylus to jot down important numbers e.g. when you're driving or on the phone, launch BigButton.
You can easily push the big buttons on your Palm screen using your fingers (pointer or thumb).
No need to pull-out your stylus! It easily memorizes 80 digits that can be seaprated by "
Other Software by developer «Peter Ohler»:
EV1Dash EV1Dash is a program for Palm OS devices that will collect data from the EV1 and display it on the Palm OS device display. The intent is to provide more information to the driver so that range and performance can be optimized. Here is one of the displays. There are two other displays
