EVDash is a Palm OS application that acts as a set of dash board gauges for electric vehicles. It displays battery pack voltage, amps being drawn from the battery pack, and two different estimates of remaining battery capacity. It works with Xantrex's Link 10, formerly called the E-Meter. Just plug the Palm device into the E-Meter, preferably through an optical isolator to protect the Palm device and start the EVDash program.
- Voltage - Battery pack voltage.
- Amps - Amps being drawn from or put back into the battery pack.
- Capacity based on voltage - Capacity calculated from the pack voltage under very low load. Voltage drops off as pack capacity drops.
- Capacity based on amps - Capacity calculated from the amps drawn integrated over time compared to the pack capacity. The peukert effect is taken into account.
Once you install the EVDash.prc on the Palm pull down the menu and go to the setup window. Enter the pack capacity and the Peukerts constant. The state of charge voltages should be determined experimentally by recording the voltages as the battery pack is completely discharged.
To transfer ASCII data from your Palm, use the standard Hot sync cable and a terminal program. Set the following communications information:
Supported operating systems:
Palm OS 3.x, Palm OS 4.x, Palm OS 5.x
Similar Software:
FrameTX FrameTX removes the 2-pixel wide white border around the screen in T|X, LifeDrive, and T|T5
PowerButton Hack PowerButton Hack - With PowerButton Hack you can have your palm ready upon startup with whatever program you choose!
You can set a specified application to run upon turning on your palm
SyncBack SyncBack is the preference panel that automatically restart an application after execution of HotSync
UpDnHack UpDnHack - This is a simple hack which toggles between PgUp and PgDown hardware buttons.
I read a lot from my Palm Vx device and I found that plam's PgDown button is not convenient enough
Power Hero Power Hero helps you to get the best out of your Battery!
Power Hero has a host of features to maximize the battery life of your Treo
Tweak User Tweak User - Tweak User allows to operate multiple PalmOS handhelds with the same user name but synchronise them to different user accounts on the desktop application
List Hack List Hack is a small system extension that will scroll through a standard list when the up/down buttons are pressed. I created this hack, because I found I was pressing the scroll buttons and expecting a list to scroll, and because it didn't I had to tap the to small buttons in the list itself
TopCommandBar TopCommandBar - This product was created for Handspring/palmOne Treo 600, Treo 650, and Treo 700p only. It will not work on other devices than Treo 600, Treo 650, or Treo 700p.
Command bar is an important Palm OS feature that is missing on the Treo devices for no apparent reason
SoundBlinkHack SoundBlinkHack - SoundBlink Hacks allows to control sounds on a simple level.
Basically, it allows you to mute or redirect any sound from any application at a given time.
You can define for a given period of time that all sounds should be muted and that the LED should blink instead.
Or that certain applications should use the vibrating facilities of your device
Screen 40% Shortcut for Power Hero Screen 40% Shortcut for Power Hero - This is a shortcut for Power Hero that helps you quickly manage power on your Treo or Centro smartphone. You might want to link it to a favourite so you can use Butler's keylauncher to press and hold a key and do the relevant job. It requires Power Hero to be installed
Other Software by developer «Peter Ohler»:
EV1Dash EV1Dash is a program for Palm OS devices that will collect data from the EV1 and display it on the Palm OS device display. The intent is to provide more information to the driver so that range and performance can be optimized. Here is one of the displays. There are two other displays
