Channel buttons & Up/Down DPAD: select current channel
Connection light:
the small light at the bottom of the screen under the divider between the
40h buttons and channel buttons shows the status of the connection.
Yellow = Connecting
Green = Connected
Red = Disconnected/Error
By default it starts in local loopback mode, press START to connect.
There is no config menu in this version and you are stuck with the first WFC profile.
Future plans:
- glowing channel buttons showing data flow (33% = data, 66% = selected, 100% = both)
- actual emulation of a monome 40h / wrapper for running monome firmware
- wfc selection
- 2nd display-only monome
NOTE: this program is NOT from, licensed by, or supported by monome.
Like it? Share with your friends!
If you got an error while installing Themes, Software or Games, please, read FAQ.
Similar Software:
Comments on Monome DS:
Comments not found
If you noted an error or download link is broken, please, report it via this page or use comments.
Please, select device to check if Monome DS supports it